DESCRIPTION: High quality, high strength PASTE adhesive suitable for use on most masonry,concrete, cement sheets, & building boards.This adhesive is manufactured to the Australian Standards 2358.1990

USES: For the installation of Ceramic, Mosaic, Slate, Terracotta, quarry and Marble, Porcelain, ectů DO NOT USE BETWEEN TWO IMPERVIOUS SURFACES. WALL TILING ONLY and not suitable for complete submerge.

PREPARATION: The surface to be tiled must be firm and clean, free from dust, laitance waxes, paint and other contaminants. Steel floated concrete floors must be mechanically roughened and washed thoroughly prior to tiling. Prime concrete and Masonry with EVERPRIME.Prime all difficult surfaces with SUPERBOND or EM22

MIXING: NO MIXING REQUIRED

APPLICATION: Tiling should be to Australian Standard AS 3958.1.1991 Spread adhesive onto surface using an appropriate size trowel to ensure maximum contact to back of tile. Ensure that the adhesive is wet and not skinned over when tiles are laid, and tap the tile into place..

COVERAGE: Approximately 1 square meter  per litre

SAFETY: When mixing wear appropriate gloves, goggles, dust must or chemical mask, enclosed footwear & clothing to cover skin MUST BE WORN. If product gets in eyes, irrigate immediately with clean water. Then seek further help from Doctor if needed.

When applying product avoid skin contact or get in eyes. Solvent based products MUST have area well ventilated and DO NOT SMOKE or work near naked flame. Do not swallow, not allow drying on skin or in hair.

Site safety procedures requirements also must be met, so please contact the safety office if applicable. For more information consult M.S.D.S available at Everbond on request or the safety officer! Or contact Everbond 1800 044 004

Stikwell

PREMIXED WHITE PASTE WITH SUPERIOR NON- SLIP PROPERTIES & VERY FLEXIBLE FOR INTERNAL WALLS, SUITABLE FOR FIX POROUS & NON POROUS TILES

[Home Page] [Company Profile] [Guarantee] [Projects] [Product Range] [Contact Us] [Surfaces Preparation ]

 

NOTICE TO CUSTOMER

Everbond have no control on the application of this product or preparation of substrata, so it is the sole responsibility of the purchaser to ensure that this product is the correct material for the job.

Please ensure all instructions and or Technical Sheets are read before carrying out any work.

Everbond will not be liable for consequential damage or loss either direct or indirect arising out of the products miss use.